![]() I went with 65,5 mm from toe hole to center holes. I'll report back.Īlso thanks to Lucknau and I think Knut for the template. I have some friends on them and they're not having any issues. I considered what you said, but ended up with Shifts. SoVT thanks for your response before, I was attempting to respond using my phone and ended up deleting my original post. I'd rather have more brake/heel on the track than less. ![]() This is how the heel piece ended up, not much room for a bigger boot, by my feet at this point aren't getting any bigger, and I just got new boots. You can see where I punched out at 340 to move them back for my first attempt, but didn't like where the heel ended up in the track. I used the template for the toe as it's printed at my 326 BSL, but moved the heel template forward about 16mm, so I'm putting the 309 mark on the line to get this offset. Top is towards the tip of the ski, dots are over the old STH mounting holes, X's are shift mounting holes, Circle w/ X are the shared toe holes. Since the heal on the shift had 30mm, I just moved the template about 16mm forward. They seem to be a perfect match.įor the heel, the most rearward holes conflict. I haven't heard any reports back on this, so thought I'd throw this out here.įor the toe you can reuse the rearward holes from the STH's for the 2 middle holes for the shifts. I just finished mounting shifts on some ON3P's that had STH1's.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |